Thank you for using Autodesk® Vehicle Tracking 2018.
This readme contains important information about Autodesk® Vehicle Tracking 2018 Hotfix 1, which may not be included in the 2018 Readme or the Help. For reference, save or print this document. It is strongly recommended that you read this entire document before you install.
Autodesk Vehicle Tracking Hotfix 1 Fixed Issues:
Fixed an issue where opening some files in AutoCAD or AutoCAD Civil3D repeatedly displayed messages about entities containing data produced by a newer version of Vehicle Tracking. The messages now indicate that updating to Autodesk Vehicle Tracking 2018 Hotfix 1 will resolve the issue.
Fixed an issue where roundabout baseline targeting flags were not being set for new roundabout baselines.
Fixed an issue where a Blank Dialog Box appeared when running a Vehicle Tracking Command or a Civil 3D Roundabout Command while opening a drawing that contains data from a newer version of the application. Autodesk Vehicle Tracking will now warn you that all commands will be disabled when opening a drawing file from an unsupported application version.
Fixed an issue of holes appearing in the roundel area around splitter islands for roundabouts corridors that have Stockdale crown lines.
Fixed an issue of small lumps appearing in roundabouts on Stockdale crown line curves between the yield line and the roundel crown line.
Fixed an issue where the exit side crown line occasionally stayed at elevation 0 for single arm roundabouts.
Fixed an issue where the profile report did not display the vehicle side view in either vehicle diagram, or when inserted into a drawing.