Notice to Autodesk Inventor Customers: Inventor 2016.2.6 Hotfix Released

In our continuing efforts to provide high quality products, Autodesk has released Inventor 2016.2.6 Hotfix which addresses multiple issues (see Description below).

This document contains the latest information regarding the installation and use of this hotfix. It is strongly recommended that you read this entire document before you apply the hotfix to your product. For reference, you should save this document to your hard drive or print a copy.

Contents

Return to Top

Return to Top

For application of this Update, your system must have Inventor from one of the following products installed:

Return to Top

This hotfix is available in 64bit version and is only applicable to Autodesk Inventor 2016 Service Pack 2. If you do not have Service pack 2 please download and install prior to installing this hotfix. Once installed, it will appear as an update under Add/Remove Programs and can be uninstalled from there.

  1. Update your operating system before you install this Autodesk Inventor 2016 Service Pack 2 hotfix. Reboot your system after the updates are installed.
  2. Download the hotfix.
  3. Double click the .msp file downloaded in step 2 to install this hotfix on each system running Autodesk Inventor 2016 Service Pack 2.
  4. Choose Next to begin the install...
  5. Once finished you'll receive the Autodesk Inventor 2016 Setup dialog box stating that the hotfix has been successfully applied.
  6. Click Finish to complete the installation and exit the dialog box.

Return to Top

We thank all our customers who identified these issues and reported them to us. These reports give us the opportunity to improve the product and provide you with the best solution in mechanical design. We also thank you for your continued business and for feedback regarding the content of this update release.

Return to Top


Copyright © 2017 Autodesk, Inc.